SGI InfiniteStorage 4000 Series Podręcznik Użytkownika Strona 62

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 122
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 61
44 007-4834-001
4: Replacing Enclosure Components
1. Check TPSSM for instructions on drive failure recovery procedures. Follow any
instructions provided by the software before proceeding.
Caution: Removing the wrong drive can cause data loss. Ensure that you remove
only the failed drive. The drive fault indicator of the failed drive module illuminates
amber. Removing a drive module while its green activity indicator is blinking can
cause data loss and may cause the host controller to mark the drive as failed. If you
remove an active drive accidentally, wait at least 30 seconds and then reinstall it. See
TPSSM for further recovery instructions.
2. Locate the failed drive module (its fault light should be on).
3. Wearing antistatic protection, lift (open) the lever of the failed drive module (see
callout 1 in Figure 4-1).
4. Pull out the drive module (see Figure 4-1).
5. Wait at least 30 seconds for the management software to recognize the drive’s
removal, then go on to the next steps and install the replacement drive in the
enclosure.
Figure 4-1 Removing and Installing a Drive Module
6. Unpack the new drive module if you have not already done so. Save all packing
materials in case you need to return the module.
!
Przeglądanie stron 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 121 122

Komentarze do niniejszej Instrukcji

Brak uwag