SGI Ethernet Card Podręcznik Użytkownika

Przeglądaj online lub pobierz Podręcznik Użytkownika dla Networking SGI Ethernet Card. SGI Ethernet Card User`s guide Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 1 - Network Adapter User’s Guide

SGI®10-Gigabit Ethernet PCI ExpressNetwork Adapter User’s Guide007–4983–002

Strona 2 - Sicherheit

ContentsVerifying that the Adapter is Properly Configured and Enabled ... 9Resetting the Adapter . . . ... 10Changing the Configura

Strona 3 - Japanese Compliance Statement

FiguresFigure 2-1 Fiber Optic Connections . . . ... 6007–4983–002 xi

Strona 5 - New Features in this Guide

TablesTable 1-1 10-Gbit Cable Standards . . . ... 3Table 3-1 Faceplate LEDs . ... 8007–4983–002 xiii

Strona 7 - Record of Revision

About this GuideThis guide describes the SGI 10-Gigabit (Gbit) Ethernet PCI Express network adapter.It requires one of the following SGI ProPack for L

Strona 8

About this GuideScope of this GuideThis guide is written to facilitate installation of the adapter and does not coverdetailed points of network configu

Strona 9

SGI®10-Gigabit Ethernet PCI Express Network Adapter User’s Guide• Standard Linux man pages that are useful for any Ethernet device:ethtool(8)ifconfig(

Strona 10 - Contents

About this Guide[ ] Brackets enclose optional portions of a command ordirective line... Ellipses indicate that a preceding element can berepeated.Pro

Strona 11 - 007–4983–002 xi

Chapter 1Features and CapabilitiesThis chapter discusses the following:• "SGI Systems Supported" on page 1• "Key Features" on page

Strona 12

COPYRIGHT© 2007 SGI. All rights reserved; provided portions may be copyright in third parties, as indicated elsewhere herein. No permission isgranted

Strona 13 - 007–4983–002 xiii

1: Features and CapabilitiesNote: SGI does not support dual-protocol or 10–Gigabit Myrinet.• Wire-speed performance.• Firmware-controlled offload engin

Strona 14

SGI®10-Gigabit Ethernet PCI Express Network Adapter User’s Guidefrom 400-MHz * km to 2000-MHz * km, depending on its length, as shown in Table1-1.Tabl

Strona 16 - Related Publications

Chapter 2Connecting the Adapter to a NetworkTo install the SGI 10-Gbit Ethernet PCI Express network adapter, refer to theinstructions for installing a

Strona 17 - Conventions

2: Connecting the Adapter to a NetworkFiber-opticconnector Figure 2-1 Fiber Optic ConnectionsFor information about configuring the interfaces, see The

Strona 18 - Reader Comments

Chapter 3Operating the AdapterThis chapter describes various issues that may occur when using the SGI 10-GbitEthernet PCI Express network adapter in a

Strona 19 - Features and Capabilities

3: Operating the AdapterTable 3-1Faceplate LEDsLabel Color MeaningSYellow Controlled by the adapter’s firmwareLGreen Link connectivityRGreen Receive (R

Strona 20

SGI®10-Gigabit Ethernet PCI Express Network Adapter User’s GuideEnabling the AdapterTo enable the adapter, enter the following:[root@linux root]# ifco

Strona 21 - Configuration Limits

3: Operating the AdapterResetting the AdapterIn the unlikely event that you need to reset the adapter, enter the following, where Nis the adapter numb

Strona 22

SGI®10-Gigabit Ethernet PCI Express Network Adapter User’s Guide2. To change the MTU size of the 10-Gbit Ethernet adapter, enter the following,where N

Strona 23 - 007–4983–002 5

AttentionCet appareil numérique n’émet pas de perturbations radioélectriques dépassant les normes applicables aux appareils numériques deClasse A prés

Strona 25 - Operating the Adapter

Chapter 4Performance TuningThe default settings have been carefully chosen to maximize throughput for the SGI10-Gigabit (Gbit) Ethernet PCI Express ne

Strona 26 - Verifying Adapter Recognition

4: Performance Tuningsizes were chosen to be compatible with those recommended by the cardmanufacturer and required by SGI’s software. To set the netw

Strona 27 - Enabling the Adapter

GlossaryEthernetA communication network used to connect computers.gigabit (Gbit)A communication rate of 10^9 bits per second.hostAny system connected

Strona 28 - Setting MTU Sizes

Glossaryman (manual) pageAn online document that describes how to use a particular command. Also calledreference page.multiclient configurationA TCP/IP

Strona 29 - Troubleshooting

Index10GBASE-SR, 51000-Base-SX, 3Aadapter enabling, 9adapter resetting, 10Altix systems, 1Altix XE systems, 1Ccabling, 2configuration changes, 10configu

Strona 30

IndexOoperating, 7Pperformance tuning, 13ports, 3/proc/net/dev, 8Rread/write size, 13receive (RX) traffic, 8recv calls, 13resetting the adapter, 10S/sb

Strona 32 - TCP Time Stamps

New Features in this GuideThis revision includes additional SGI performance tuning recommendations. SeeChapter 4, "Performance Tuning" on pa

Strona 34 - 16 007–4983–002

Record of RevisionVersion Description001 April 2007Original publication002 October 2007Revision007–4983–002 vii

Strona 36 - 18 007–4983–002

ContentsAbout this Guide ...... xvAudience . . ....... xvImportant Information . . . ...... xvScope of th

Komentarze do niniejszej Instrukcji

Brak uwag